How To Measure Longboard Truck Size

A longboard is a type of skateboard with a longer deck, usually between 33 and 60 inches long. Longboards are used for transportation, cruising, and racing. The trucks are an important part of the longboard, and the size of the trucks can affect the performance of the longboard. The size of the trucks is measured in inches, and the most common sizes are 150mm, 180mm, and 200mm. The size of the trucks can also be affected by the width of the deck.

Read Also: Difference Between Longboard and Skateboard

10 Ways For Measure Longboard Truck Size

10 Ways For Measure longboard Truck Size

1. Measuring for longboard trucks is simple if you have the right tools. You will need a measuring tape, a ruler, and a hard surface to lay your longboard on. 

2. Place the longboard on the hard surface and measure from the end of the nose to the tail. This is the deck length and will help you determine what size trucks you need. 

3. Use the measuring tape to measure the width of the deck at the widest point. This is the deck width and will also help you determine what size trucks you need. 

4. To determine the wheelbase of the trucks, measure from the center of the front axle to the center of the rear axle. 

5. To find the right size trucks, you will need to know the deck length, deck width, and wheelbase. Once you have these measurements, you can consult a longboard truck size chart. 

Read Also: Install Drop Through Trucks

6. Another way to determine the right size trucks is to test them out on your longboard. Place the trucks on the board and see how they feel. If the trucks are too small, they will make the longboard feel unstable. If the trucks are too big, they will make the longboard difficult to maneuver. 

7. Once you have found the right size trucks, it is important to adjust them to the proper width. The width of the trucks should be narrower than the width of the deck. This will help the longboard turn more easily. 

8. To adjust the width of the trucks, loosen the kingpin nut and move the hanger to the desired width. Once the hanger is in the desired position, tighten the kingpin nut to keep the hanger in place. 

9. The final step is to adjust the height of the trucks. The height of the trucks should be flush with the deck or slightly lower. This will help the longboard glide smoothly over obstacles. 

Read Also: How to Clean Longboard Wheels

10. To adjust the height of the trucks, loosen the kingpin nut and raise or lower the baseplate until it is at the desired height. Once the baseplate is in the desired position, tighten the kingpin nut to keep it in place.

Conclusion

There is no definitive answer when it comes to measuring longboard truck size. The most important factor is to make sure that the trucks are compatible with the longboard deck. Once that is confirmed, the next step is to determine the desired width and height of the trucks. From there, it is simply a matter of personal preference as to which size trucks to use.

Leave a Comment

Your email address will not be published.